I have a 2002 ford explorer xls that was purchased new.
02 explorer no door lock.
They wont work with the fob or the combination pad outside the door either i need to know where the door lock relays are located and would love to have a door lock wiring diagram i already removed the drivers door panel and the rubber wire duct in the door jamb and found a red wire broken and tada.
Press the unlock control then press the lock control.
Approximately 1 year after purchase started developing a crack on the panel beneath the rear window.
Press the power door lock button once and listen for the horn to beep one time.
Older versions used a plunger that you could easily test with with your fingers.
One beep confirms the auto locks have been disabled.
The first thing to get keyless entry door factory code you need to locate the passenger fuse panel.
Turn the ignition back to on.
Average failure mileage is 95 400 miles.
Press the power door unlock control three times.
The common problem is that the switch is not closed this will cause your dome lite to be on door ajar light on and will malfunction any aftermarket auto alarm.
The horn will chirp once if auto lock was deactivated or twice one short and one long chirp if auto lock was activated.
Ford explorer since 1995 has been using an in door switch for the door jamb.
No door is opened but the doors refuse to lock and the warning light stays on.
The horn will chirp.
Since then when it is hot i get a door open warning light.
Two beeps one short and one long signals that the auto locks have been enabled so if you receive two beeps start the process over again.
My 02 ford explorer power door locks just up and quit all at the same time.
2002 ford explorer door ajar problem fixed.
On the 2011 2018 ford explorer the passenger fuse panel is located under the instrument panel to the left of the steering column.
The 2002 ford explorer has 7 problems reported for power door lock not working.